Ty
07-27-2009, 09:26 AM
This is just to show what a GOOD single step polish can do. I had to mix polishes a little, 90% of the single step with diminishing abrasives, and 5% of a heavy compound for a little more cut.
I used a Lake Country Green foam pad at about 1800 RPMs with medium pressure and finished it off at 1400RPMs with light pressure.
The swirls were quite deep, but I was able to correct about 90% of them. Not bad for a single step with one pass.
Left side untouched, right side after 1 pass.
http://tyleh.com/image_files/DSC_1888.JPG
I used a Lake Country Green foam pad at about 1800 RPMs with medium pressure and finished it off at 1400RPMs with light pressure.
The swirls were quite deep, but I was able to correct about 90% of them. Not bad for a single step with one pass.
Left side untouched, right side after 1 pass.
http://tyleh.com/image_files/DSC_1888.JPG